Bva-hydraulics PS33L Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pompes Bva-hydraulics PS33L. BVA Hydraulics PS33L User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 4
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
BVA e-pump Solenoid Valve Conversion
PS33L Single Acting Kit
PS43L Double Acting Kit
IMPORTANT: READ ALL THE INSTRUCTIONS BEFORE YOU PROCEED
WITH MAKING THE CONVERSION. BVA WARRANTY DOES NOT COVER
ELECTRICAL OR MECHANICAL DAMAGE CAUSED BY IMPROPER
E-PUMP CONVERSION. Familiarize yourself with all parts, tools and procedures
before starting the conversion. THIS KIT IS DESIGNED BE INSTALLED ON A
BVA E-PUMP MODEL PE…PEM…OR PEW…
Parts included in the BVA e-pump (single acting - S/A) or (double acting - D/A)
conversion kit.
Part No. Description Quantity
1. 655011 Dynex solenoid valve 1
2. C33L S/A or C43L D/A Locking valve 1
3. E05-4-9201-101 Solenoid valve conversion kit with 1
connecter tube, gasket, acorn/collet connector and 4 bolts.
4. Misc. Yellow wire nut 1
5. Misc. Wire cable tie 1
Tools needed to complete the conversion.
1. 8mm or 5/16” or hex wrench
2. Number 2 Phillips screwdriver
3. Pliers conventional or electrical
4. Wire stripper
5. A 5/32 inch or 3/16 inch drill bit for BVA models PE…and PEM… only, the drill bit
is not needed for PEW… because the hole already exists for the pendant remote.
6. A cone shaped 3/4 inch step drill bit for sheet metalusing a conventional twist
drill bit will mangle the junction box cover. This bit is only needed for models PE…
and PEM… only, the drill bit is not needed for PEW… as above in line number 5.
7. Cloth shop rag or paper towels.
Page 1
Vue de la page 0
1 2 3 4

Résumé du contenu

Page 1 - PS43L Double Acting Kit

BVA e-pump Solenoid Valve Conversion PS33L Single Acting Kit PS43L Double Acting Kit IMPORTANT: READ ALL THE INSTRUCTIONS BEFORE YOU PROCEED WITH

Page 2

TO BEGIN THE CONVERSION 1. MAKE SURE THE POWER CORD IS UNPLUGGED. On the junction box that says TECO remove the single Phillips screw and pop the

Page 3

THE JUNCTION BOX 5. From the solenoid valve conversion kit install the plastic acorn/collet wiring connector into the 3/4 inch hole you drilled in t

Page 4 - To Dynex

Motor 1-3-5 2-4-8 To Dynex Power cord Toggle switch White Black Green Green White Black Ground

Modèles reliés PS43L

Commentaires sur ces manuels

Pas de commentaire