3
!
Be sure all tools and personnel are clear
before lowering load. Only attachments and/or
adapters supplied by the manufacturer shall be used. Lift
only on areas of the vehicle as specied by the vehicle
manufacturer.
! WARNING
• Study, understand, and follow all printed materials
provided with/on this product before use.
• Do not exceed rated capacity.
• This is a lifting device only!
• Immediately after lifting, support the load with
a pair of appropriately rated jack stands.
• Use only on hard, level surface.
• Do not use adapters or accessories that are not pro-
vided initially.
• Lift only on areas of the vehicle as specied by the
vehicle manufacturer.
• No alterations shall be made to this product.
• Failure to heed these markings may result in personal
injury and/or property damage.
To avoid crushing and related injuries:
•
Never work on, under or around a load supported only
by hydraulic jack.
•
Always use adequately rated jack stands.
• Chock each unlifted tire in both directions.
• Do not use this device to lift, level, lower, support nor move
a house, mobile home, travel trailer, camper or any building
structure.
• Be alert and sober when using this product. Do not operate
under the inuence of drugs or alcohol.
! WARNING
X
OPERATION
Raising the Ram Plunger
1. Assemble handle, ensure that spring clips align with slots.
2. Place vehicle in the park, with emergency brake on and wheel securely chocked to prevent inadvertent vehicle movement.
3. Locate and close release valve by turning handle clockwise until rm resistance is felt to further thread engagement.
4. Verify lift point, center jack saddle under lift point.
5. Insert the handle into the handle sleeve, then pump in order to raise saddle to contact lift point. To lift, continue pumping until
load reaches desired height.
6. Immediately secure lifted load with appropriately rated jack stands.
Use only the handle provided by jack manufacturer. The handle provided with this jack will safely engage
the release valve. If handle is worn, operates abnormally, or will not positively engage the release valve,
STOP, discontinue use of the jack until a factory replacement handle can be acquired.
Do not use an extender on the operating handle.
Lowering
Make certain that all personnel are clear of the load before lowering. Control the rate of descent of the
load at all times. The more you open the release valve, the faster the load descends.
1. Raise load high enough to clear the jack stands, then carefully remove jack stands (always used in pairs).
2. Slowly turn the handle counter-clockwise, but no more than 1 turn. If the load fails to lower:
a. Use another jack to raise the vehicle high
enough to reinstall jack stands.
b. Remove the affected jack and then the stands.
c. Lower the load by turning the release valve counter-clockwise, but no more than 1 turn.
3. After removing jack from under the load, push ram and handle sleeve down to reduce exposure to rust and contamination.
!
!
!
(4 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels